Oxyhydrogen is a mixture of hydrogen and oxygen gases. This gaseous mixture is used for torches to process refractory materials and was the first gaseous mixture used for welding.
Running a Motorcycle on Water HAS been Achieved!
For the full Haul N Ride Article complete with videos that demonstrate motorcycles and small combustion engines running on HHO (Oxyhydrogen) Click Here..
All the difficult work has been done for you. Cutting the 316 Stainless Steel Plates, drilling and assembly, all done 🙂
HHO Entry Level 21 Plate Dry Cell Complete Starter Kit.
Bonus 30 Amp PWM (Pulse Width Modulator to assist breaking the covenant bond in H2O).
This is no doubt the most complete HHO On Demand Starter Kit you will find for this low price.
At peak efficiency you can expect this cell to produce sufficient HHO at around 10 to 14 amps at 13.2 volts to give substantial benefit to up to a 4500cc (4.5 litre) engine.
These HHO dry cells, and for that matter any Hydrogen on demand system added to a vehicle with a stock alternator, run at peak performance at under 20 amps. This is because at over 20 amps the alternator must work harder which in turn causes the engine to work harder, which uses more gas.
If more HHO is needed, it is better to add more cells than increase the amperage, as this can often boil the cell which will produce steam and give a false indication of HHO output.
This Cell is ready to go just add electrolyte and power up!
- Assembled 21 Plate Dry Cell
- 1800 mm reinforced 1/4″ tubing
- 6 Cable ties
- 12 Self Tapping Mount Screws
- 8 Hose Clamps
- 1 x 30 AMP Gauge
- Purpose built HHO 1 litre Bubbler tank
- 1 Vaporizer/Scrubber/Spark arrestor
- 1 x 1/4 Check valve
- 30 amp waterproof fuse
- Bonus 30 amp PWM (Pulse width Modulator)
- 30/40 AMP RELAY
- All electrical tabs and fittings needed